Criteria for scrapping hooks: The hooks should be inspected regularly. If one of the following conditions is found, the hooks must be scrapped and replaced. 1. When the surface has cracks and cracks, the opening is increased by 15% compared with the original size. 2. Dangerous section and hook neck have permanent deformation, torsion deformation exceeds 10 degrees; 3、 The wear of the section of the hanging rope is more than 10% of the original height. 4. Plastic deformation occurs in dangerous section and hook shaft.
Related Posts
Marking method for the characteristics of steel wire rope China JBY Supply
The diameter of the wire rope is 18mm, the steel wire (no plating), 6 strand of natural fiber core, right twist twist , the tensile strength of the steel wire is 1770MPa, the minimum breaking tension of the steel wire is 176kN, and the... read more
Specification for safe use of shackles China JBY Supply
Shackle,Eyebolt, Hoist hook,Wire rope are the main end fittings of sling rope and hanger. Whether they are used correctly or not is directly related to the load-bearing safety of hanger and hanger. The standard use of shackles can extend the service life of shackles and ensure... read more
Performance characteristics and maintenance of die forging shackles China JBY Supply
Performance characteristics of die forging Shackles: 1. The unloading body is forged by high-quality carbon structure or alloy structure and stops heat treatment. It has small volume and high strength. 2. The experimental load of the shackle is 2 times the limit working load, and the... read more
Repair of wire rope in use China JBY Supply
As a part of rigging, wire rope rigging plays a very important role in hoisting engineering. However, the wire rope can not be used casually, in the process of hoisting there are also a lot of things to pay attention to. Below, give you... read more
Crane hook grade and material requirements China JBY Supply
The grade of the hook depends on the mechanical properties of the finished hook. The rated lifting weight and grade are defined by the rated lifting weight and test load, which are expressed by the letters M, P, S and T respectively. The basic design... read more
Outstanding Performance and Characteristics of Turnbuckle China JBY Supply
Turnbuckles is mainly used for tightening or adjusting tension. It can be used for chain, steel rope and steel support. Make sure that at least 25% of the screw length has entered the main body of the basket screw. When using turnbuckles, we must strictly... read more
Rigging rust prevention China JBY Supply
Metal corrosion is a spontaneous process of metal transformation from high potential energy unit to compound. Sling gear is a hardware and mechanical tool. Without effective protective measures, corrosion will be inevitable. Therefore, the sling will face the problem of anti-rust in the process... read more
Operation management of hoisting machinery China JBY Supply
1. management of operators Operators should learn and master the relevant knowledge of the structure, working principle, technical performance, safety operating procedures, maintenance and maintenance system of the hoisting machinery used and the relevant national laws, regulations and standards before they go on duty. After... read more
Precautions for hoisting articles China JBY Supply
In order to ensure the safety and reliability of the object in the process of hoisting, the binding method should be selected according to the weight, shape feature, installation requirement and hoisting method of the object before lifting. There are two main methods: (1)... read more
Use and precautions of eye hoist hook China JBY Supply
The eye hoist hook should pay attention to the environmental conditions when it is used in conjunction with the rigging, and the rigging should not be twisted and knotted. During the lifting process of the hook, the articles that are strictly forbidden to be... read more